Flooring Contractor in Stamford CT
Stamford homeowners trust us to install hardwood, tile, and luxury vinyl with zero mess left behind.
Stamford is Fairfield County’s largest city, and the housing stock reflects that. Colonials and ranch homes from the 1940s and 1950s are common across Springdale, Belltown, and Turn of River. Original wood floors, aging subfloors, and decades of settled structure are normal here.
We have installed wide-plank white oak in a 1950s colonial off High Ridge Road and refinished original hardwood in a Springdale split-level where the floors had been buried under linoleum since the 1970s. Rick Shepard, founder of this wood floor installation service in Westport CT, has led every project for over 40 years.
Wood Floors of Westport is 13 miles up I-95 from Stamford, and we are out here regularly.
Flooring Work in Stamford
Stamford keeps us busy. Post-war ranch homes in Glenbrook, colonials in North Stamford, cape cods in Westover. Every property type comes with its own floor conditions and building-era quirks.
We have pulled up carpet in a 1960s ranch near Courtland Avenue and found original red oak underneath that was worth saving. Last fall a Belltown colonial got a full install while three kids and a dog were still living in the house. The family was back on their floors by the end of the week.
Every visit out here turns up something different. That is fine with us.
Stamford Colonial and Ranch Homes
The postwar colonials and ranch homes across Springdale, Belltown, and Westover are the core of what we work on here. Built fast, often with narrow-plank oak that has held up well but was never set on a perfectly level subfloor. Sixty years of settling shows up the moment you put a level on the floor.
Wood Floors of Westport has been working in Fairfield County for decades, and Stamford’s construction patterns are not a surprise to us. We have installed 3.25-inch select red oak in a Springdale colonial where the original floors had been painted over. Project photos and details are on the flooring contractor in Westport CT page.
Old houses need experienced hands.
Condo and Multi-Unit Properties
Stamford has a large condo and multi-unit inventory around Downtown, Harbor Point, and the Glenbrook corridor, and working in those buildings is not the same as working in a single-family home. Concrete subfloors, HOA sound-mitigation rules, phased scheduling to avoid disrupting neighbors, finishes that hold up in shared entryways.
We have installed engineered hardwood over concrete slab in a Harbor Point unit where solid wood was not an option. A Bedford Street multi-family building needed phased work on a tight schedule, and 5-inch engineered plank was the right call for that floor.
Get the scheduling and prep wrong and the whole job falls apart. These buildings have taught us exactly where the problems come from.
Hardwood Floor Refinishing
Stamford has a lot of original hardwood still in the ground. Colonials off Long Ridge Road, Westover cape cods, split-levels in Springdale. Most of it has not been touched in 20 or 30 years, and in most cases it does not need replacing. It needs refinishing.
Over on Shippan Point, a home had 2,400 square feet with significant surface damage but solid structure underneath. We refinished it. One North Stamford colonial needed custom stain work to match new cabinetry. The owners wanted a matte white oak look with a wide-plank feel. Refinishing before a listing is one of the most noticeable improvements a Stamford homeowner can make, and buyers pick up on it fast.
Good bones are worth saving.
Subfloor Preparation
High moisture near the Shippan and Waterside areas. Joists that have moved in 1950s and 1960s colonials. Subfloors patched by a previous owner and never properly leveled. Any of these will cause new hardwood to squeak, gap, or cup if not corrected before installation starts.
On Washington Boulevard, decades of settling had left a visible slope across the living room. In Glenbrook, moisture intrusion in a basement-adjacent room required barrier work before engineered wood could go down. Skipping that step is one of the most common reasons floors fail within a few years, and it is why every job gets scoped before it gets priced.
Wood Floors of Westport is the call when Stamford homeowners want the work done right.
We also serve nearby Greenwich, Darien, and the Norwalk corridor.
Driving Directions from Stamford
Our Location: 606 Post Rd E #551, Westport, CT 06880
From downtown Stamford, take I-95 North toward Norwalk. Take Exit 17 for Saugatuck Avenue, head north, then turn right onto Post Road East (US Route 1) and continue northeast into Westport. Wood Floors of Westport is at 606 Post Rd E, approximately 13 miles from central Stamford and about 20 minutes under normal traffic.
Frequently Asked Questions (FAQs)
1. Is engineered hardwood a better choice than solid hardwood for certain rooms in a Stamford home?
For rooms over concrete slab, basement-adjacent spaces, or areas with radiant heat, engineered hardwood is the correct choice. It handles moisture variation better than solid wood, and in modern plank formats it delivers the same appearance without the cupping and gapping risk that older Stamford homes are particularly prone to.
2. How long does hardwood floor installation take in a Stamford home?
Most residential installations in Stamford run three to five days from start to finish, depending on square footage, subfloor condition, and whether site-finishing is required. We provide a realistic timeline during the initial walkthrough so nothing comes as a surprise.